Product Name: D-type seal with adhesive insulation of this product Features: foam rubber, sponge rubber strip Features: EPDM as raw material, the surface smooth and detailed, good elasticity, good foam evenly, waterproof first-class, anti-ozone aging resistance, solvent resistance are good. EPDM / rubber / foam products: a polyethylene foam rubber expansion joints board openings (. Caulk board caulking board) (a) Product Features ▲ light weight, high strength stretch, does not absorb water (instead of the traditional The three oil four felt, asphalt, cedar wood panels and other materials). Product environmentally friendly, simple construction, seepage, leakage, sealing good effect. ▲ corrosion resistance, aging resistance, high temperature + 80 ℃ ~ -45 ℃ not flowing, no distortion, no embrittlement, long service life. ▲ with independent opening bubble structure, a special type of joint appearance of honeycomb plate holes evenly distributed, you can not beat wool and cement / adhesive sealant tightly integrated, adapt to the natural expansion and contraction of change, enhanced seam sealed expansion of the seal effect. (B) the scope of application of the product can be widely used in machinery, doors, windows, walls, rivers, dams, ports and terminals, underground Chung-dong, water power, airports, bridges and other concrete sealing seams project. (C) the construction of this product according to the situation using a variety of methods can use the product to use. Longitudinal sealing seam, horizontal seam sealing seams and other special use. Construction effect: Enhanced body confined, closed the sound can be more thick, has a heavy feeling; effectively reduce wind noise, road noise passing car, enhance driving comfort, but also to prevent dust and rain into the car, you can apply to the front and rear cover sealed, waterproof and dustproof soundproof effect is obvious. Construction method: Titles 1, on the site you need to install seals and seal thoroughly flat-bit clean and dry. ~ ~ ~ 2, selected pasting bits, identify the starting point after pasting rod seal the lower end of the front door began to carry out a little pressed paste, be careful not to pull the seal a little action, try to keep the seal slowly prototype alignment Paste to paste the path to be carefully identify; position in the corner of the door frame, sealing strips to pay attention very gentle bend away type, do not bend too fast aesthetic impact. Moreover, because the glue dries quickly, so one can only painted about a centimeter length, can not figure quickly seek urgent, so as to guarantee results. ~ ~ ~ 3, all pasted in place to check and correct the D strip edges out excess glue carefully clean up after a while of time be thoughtful and meticulous hand pressing it, you can call it a day, and this time it is best not closed, doors wide open on 20 minutes after a closed door, and then the best other three --- 5 hours of normal use and then open the door. ~ ~ ~ 4, after pasting complete ban hand to pull the seal ban in three days washing wet (rain no way back ah) Try not to repeatedly switch the door within 24 hours. ~ ~ ~ 5, after the close of construction will be a little tight, please do not worry, in the first 2-3 days when you can normal. ~ ~ ~ 6, please in the first 1-2 days time pay more attention to the door is not closed, safety first. Choice of installation tips: installation location after closing seal must be positive in the state, so that it can make gum completely effect. (Note - Positive: Pressure direction perpendicular to the plane of the adhesive)